We received our dome in September and the shutter motor stopped running. It is in the closed position. The lights come on with the switch but that is it. There are three leds on the circuit board, the two left ones are lit but the one on right is always off. The battery is fully charged. I could troubleshoot this board if I had a schematic and was wondering if the 1.1 board is available. Any ideas? Thanks.
top of page
bottom of page
This may be a dumb question but is the rotator plugged in and the red light flashing? I ask this because I only get three light if the rotator is communicating with the shutter.
I’d also check all of the power lines to ensure you don’t have a broken wire, happen to me, or loose connection. In my case it was obvious since the shutter rocker switch wouldn’t light which also required a battery (BMS) reset.
As far as the schematic goes you’d need get it from ND. Steven