It seems the sensor for the shutter closed and percentage count has gotten out of sync or just not working at all. When I connect, the shutter position always read 100% open even though it is fully closed. I can use the toggle switch on the shutter motor and open it but when I send a close shutter command the shutter closes but the percentage remains at 100% open and if I don't stop the motor it would run itself to oblivion. The sensor has no impact on the motor stopping.
This is one of those "all the sudden" things. It's worked just fine for over a year.
I have the older Nexdome firmware. Build 4.0. With the older unit I'm not able to upgrade to the Beaver firmware. I suppose a factory default reset might work but I'm not sure and don't want to "brick" the firmware.
Any ideas or help is appreciated.