Home position sensor seems not to work. I tried to calibrate using "find home" without noticing the sensor. what can I do? Shutter motor sensors working fine.
Are the sensor and magnet parallel with a small gap (< 1/4") in between? I had to use double sided tape to extend my magnet closer to the sensor, and remove one of the sensor screws from the Beaver controller to rotate it parallel with the magnet. Then everything calibrated great.
Are the sensor and magnet parallel with a small gap (< 1/4") in between? I had to use double sided tape to extend my magnet closer to the sensor, and remove one of the sensor screws from the Beaver controller to rotate it parallel with the magnet. Then everything calibrated great.