Hello, I may be doing something wrong configuring the Beaver software for dome control. Working through the installation steps, I get to the section where I am enabling the dome to slave the telescope (see pic below). I am supposed to select a pick box for this action to happen (circled in green). However, I am unable to pick the box. The box is unresponsive. What am I doing wrong?
Also, I should note that I have the Beaver drivers in a folder other than the Beaver folder created with the software installation. Not sure if this is related to the problem above, but I thought I would throw it out there anyway.
Thx -Scott

Ahh Right! I had the scope turned on and connected to the PC but did not connect to ASCOM. Anyway, telescope is connected now.
Thanks for your help.